Changing Settings Using A Teranex Mini Smart Panel - Blackmagic Design Teranex Mini IP Video 12G Manuel D'installation Et D'utilisation

Changing Settings using a Teranex Mini Smart Panel

With an optional Teranex Mini Smart Panel attached, you can quickly change settings directly
from the unit itself using buttons, a rotary knob and LCD menu. You can also confirm sources
visually on the LCD and check the audio via the audio meters on the home screen.
This control panel mounts to the front of your IP Video 12G and replaces the original basic panel
that shipped with the unit.
The panels are hot swappable, so you don't even need to turn off your Teranex Mini IP Video
12G when installing.
1 Remove the two M3 screws on each side of your unit's basic front panel using a
Pozidriv 2 screwdriver and gently pull the panel away from the front of your Teranex Mini.
2 On the inside of the basic panel, you'll notice a small clear plastic tube attached to the
bottom corner. This tube directs light from the LED inside the unit to illuminate the status
indicator on the basic panel. This tube should stay attached to the basic front panel.
TIP If reattaching the basic front panel, make sure the light tube is aligned with
the slot in the front of the unit.
3 Align the connector on the rear of the Smart Panel with the adjoining connector on
the face of your Teranex Mini IP Video 12G and gently push the Smart Panel towards
the unit until the connectors are firmly seated. The Smart Panel should make a firm
connection and fit neatly inside the face of your Teranex Mini IP Video 12G.
4 Re-insert the M3 screws from the original panel.
If your Teranex Mini IP Video 12G is installed in a Teranex Mini Rack Shelf, you will need to
remove the unit from the rack shelf to access the front panel screws.
See the 'Teranex Mini Rack Shelf' section for more information.
When installing the Teranex Mini Smart Panel to your IP Video 12G, holding the panel with
your fingers and thumb aligned with the panel's rear connector will help guide it into place
The USB port is still accessible with the Smart Panel attached. To access the port, simply
open the rubber USB dust cover. With the Smart Panel installed, the front panel small switches
are covered up and no longer used. This is because all settings can now be changed via the
LCD menus.
Refer to the 'smart panel settings' section for more information on changing settings using an
optional Teranex Mini Smart Panel.
TIP The original basic panel is very strong, so if you need to mount your Teranex Mini IP
Video 12G in the back of a rack system or in areas where there are lots of cables or
activity, you can always reinstall the original basic panel.
1
2
Settings 19 19