Blackmagic Design Teranex Mini IP Video 12G Manuel D'installation Et D'utilisation page 18

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 79
Device
Click on the destination or source radio buttons to set your Teranex Mini IP Video 12G as a
source or destination unit.
Source and Destination Settings
These settings display the IP address and base port for the source and destination units.
Low Latency and Clean Switch Settings
Destination units can be set to low latency or clean switch modes. Low latency minimizes any
delay in signal from source to destination by only several lines, however when switching
between sources there may be a small disturbance as the source is resynchronized. To avoid
any disturbance or glitches when changing sources, select 'clean switch'. This removes any
disturbance when changing sources using the same video format, but adds 1 to 2 frames
of latency.
About Tab
The 'about' tab allows you to name your Teranex Mini IP Video 12G and identify individual units.
Details
To name a unit, simply click the 'name' text box and type your desired name.
Click 'save' to confirm the change
Identify
To visually identify your selected Teranex Mini IP Video 12G, click on the 'identify'
checkbox. This will flash the LED indicator on the unit's basic front panel. If you have a
Teranex Mini Smart Panel installed, you will see the smart panel buttons flash. Deselect
the checkbox to turn off the indicators.
Software Information
This information identifies which software version your Teranex Mini IP Video 12G is
running. If the unit's internal software is older than the current version that comes with
Blackmagic Teranex Setup, an 'update now' button will appear which allows you to
update the unit's internal software.
The 'about' tab in Blackmagic Teranex Setup is used to
name and identify your Teranex Mini IP Video 12G.
You can also check the version of the setup software
Settings
18 18

Publicité

Table des Matières
loading

Table des Matières