Switch Settings; Teranex Mini Rack Shelf - Blackmagic Design Teranex Mini IP Video 12G Manuel D'installation Et D'utilisation

When using the optional Teranex Mini Smart Panel, the switch settings will be overridden by the
Smart Panel settings. Your Teranex Mini IP Video 12G will retain its last settings whether applied
via switch, Smart Panel or Blackmagic Teranex Setup software. If reverting to switch control
after removing the Smart Panel or updating your converter's settings via software, you may
need to toggle switch 1 for new settings to take effect.
Even though switch settings are printed on the base of your converter, new features in later
updates can add new settings so it's worth checking the latest version of this manual for the
most up to date information. You can download the latest version from the Blackmagic Design
support center at www.blackmagicdesign.com/support

Switch Settings

Switch 1 on Teranex Mini IP Video 12G's small switches sets the direction of the unit to a source
or destination. The default state for switch 1 is 'off', which means the unit is set as a destination.
To set the unit as a source, set switch 1 to 'on'.
IP Video
DESTINATION

Teranex Mini Rack Shelf

When running multiple sources and destinations, you can use Teranex Mini Rack Shelf to install
your Teranex Mini IP Video 12G units into a broadcast rack or road case. Up to three Teranex
Minis can fit neatly onto each 1RU Teranex Mini Rack Shelf. Teranex Mini IP Video 12G units are
installed into the rack shelf by removing each unit's rubber feet, if attached, and screwing each
unit into the base of the shelf using the mounting holes underneath. The Teranex Mini Rack
Shelf ships with two original blank panels which you can use to cover gaps if you don't need to
install additional units.
For more information, check the Blackmagic Design website at www.blackmagicdesign.com
IP Video 12G
Teranex Mini IP Video 12G can be installed in the Teranex Mini Rack Shelf along with other Blackmagic
equipment that shares the same form factor, such as HyperDeck Studio Mini and Teranex Mini Converters
Refer to the switch legend
printed on the base of your
Teranex Mini IP Video 12G when
setting the unit as a source or
SOURCE
destination using switch 1
Teranex Mini Rack Shelf 23 23