Blackmagic Design Teranex Mini IP Video 12G Manuel D'installation Et D'utilisation page 17

Configure Tab
The 'configure' tab contains the network settings for your IP Video 12G. Here you can select
between DHCP and static network addresses, as well as set up the IP address, subnet mask,
and gateway for the unit. To change network settings, your Teranex Mini IP Video 12G must be
connected to the computer via USB.
The 'configure' tab lets you change network settings
when the unit is connected to your computer via USB
Routing Tab
The routing tab contains the direction settings which lets you set the unit as a source or
destination, displays important information about the source and destination network settings,
plus lets you set a destination unit to use low latency or clean switch modes.
Use the 'routing tab' in Blackmagic Teranex Setup to set
your Teranex Mini IP Video 12G as a source or destination
Settings 17 17