Removing An Ip Videohub - Blackmagic Design Teranex Mini IP Video 12G Manuel D'installation Et D'utilisation

If you want to add more inputs and outputs to your IP Videohub, or rename your IP Videohub,
simply click on the 'configure' tab and edit the settings from there. You can also edit the names
of each input and output by launching Blackmagic Teranex Setup and changing the device
name in the 'about' tab.
The inputs and outputs tabs let you assign source
and destination units to each input and output
NOTE The IP address of the created IP Videohub will match your computer's IP address.

Removing an IP Videohub

After finishing a project, you may want to remove the IP Videohub from your network. Note that
you can only remove the IP Videohub on the local host.
To remove an IP Videohub:
1 Select the Videohub you would like to remove.
2 Click on the '+' symbol and select 'Remove IP Videohub'.
3 A dialogue box will ask you to confirm the removal of the IP Videohub from your
computer. Click 'remove'.
Setting up and Routing an IP Videohub 27 27