Routing Sources And Destinations - Blackmagic Design Teranex Mini IP Video 12G Manuel D'installation Et D'utilisation

If you have a Teranex Mini Smart Panel attached, you can change this setting and more using
the LCD menu settings. You can also use the Blackmagic Teranex Setup software. Refer to the
Blackmagic Teranex Setup section for more information on how to change settings using the
setup software.

Routing Sources and Destinations

With each unit set as a source and destination, you can now route the source to the destination
unit. There are two ways you can route your IP video, including the LCD menu with an optional
Teranex Mini Smart Panel attached, or via the Blackmagic Videohub software.
Routing IP Video using Teranex Mini Smart Panel
With a Teranex Mini Smart Panel attached you can route IP video using the buttons, rotary
knob and LCD.
To route a source to a destination unit:
1 Press the menu button to enter the settings menu.
2 Rotate the knob clockwise or counter clockwise to select the 'source list'. Press the set
button to open the list.
3 Rotate the knob to select your desired source from the list and press the set button to
confirm the selection.
Press the menu button twice to return to the home screen. You will now see the video
for the selected source on the home screen.
Source List
1
2
3
4
5
6
With a Teranex Mini Smart Panel attached,
you can use the sources list in the LCD menu
to route sources to a destination
Routing IP Video using Blackmagic Videohub
If you have a larger network with multiple IP video units connected, it is much faster and easier
to route them all using Blackmagic Videohub Control. The Blackmagic Videohub software panel
lets you manage and route small to large networks of IP video units using one single control panel.
For details on how to use the Videohub software, refer to the 'Routing IP Video using
Blackmagic Videohub Control Software' section.
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Getting Started with Ultra HD 13 13