Lighting The Main Burners Manually - Rösle Videro Pure G2 Mode D'emploi

6. Hold down the control knob after the "click" for approx. 2 seconds so that the flame of the Jet Flame
can light the burner.
7. It is possible to visually check the ignition system. Look at the Jet Flame ignition area at the side from a
distance. After the ignition spark was triggered by the control knob, the gas flowing past is ignited and
a pilot flame is produced which lights the main burner.
8. If the burner does not light immediately, turn the control knob back to "•" OFF and wait 2 minutes to
allow the accumulated gas to disperse. Now you can repeat the ignition procedure.
9. When the main burner has been lit, repeat this process until all the burners are lit or until you have lit
all the burners you wish to use.
10. You can now use the control knob to adjust the flame to suit your particular requirements.
For the lowest setting, you turn the control knob anticlockwise to "MIN".
11. If you do not succeed in lighting the gas grill, refer to the section "Troubleshooting".
12. After use press in the control knob (gas valve) for the respective burner and turn it clockwise to the
position "•" OFF.
Lighting­the­main­burners­manually
1. Before starting the lighting procedure, all control knobs must be set to the position "•" OFF.
2. Open the lid of the grill before you light the main burners.
3. Open the gas cylinder valve by turning anticlockwise (at least two full turns).
4. Check all gas connections for leaks. See section "Leak check"
5. Press the right-hand control knob inwards and slowly turn it anticlockwise to the position "MAX".
6. In exceptional cases, the grill can only be lit with a match.
7. To do so, use a match that is at least 90 mm long and insert the
burning match through the lighting hole on the right.
8. Once the right-hand burner has lit, the burner next to it can be
turned on and will then light automatically. Repeat the process
until all the burners are lit or until you have lit all the burners you
wish to use.
9. You can now use the control knob to adjust the flame to suit your
particular requirements.
For the lowest setting, you turn the control knob anticlockwise to
"MIN".
10. If you do not succeed in lighting the gas grill, refer to the section "Troubleshooting".
11. After use press in the control knob (gas valve) for the respective burner and turn it clockwise to the
position "•" OFF.
57