Rösle Videro Pure G2 Mode D'emploi page 72

Problem Solution
Leak •
•
•
•
•
•
•
The Prime Zone •
(optional) "flares
up" when in use.
The burner makes a •
loud "whoosh" •
noise, followed by a
Switch off burner and allow to cool down for at least 2 minutes. Start up burner again and
continuous hiss and
operate at high flame for at least five minutes or until the ceramic surfaces heat evenly.
then stops heating.
Ensure that no more than 75 % of the grill area is covered with pots and pans or accessories.
Switch off burner and allow to cool down for at least 2 minutes, then restart it.
Allow burner to cool down and carefully check it for cracks. If there are cracks, contact an
authorised dealer to order a replacement Prime zone.
Other problems not Contact your specialist retailer. E-mail us at reklamation@roesle.de
listed here
Do not line the bottom funnel with aluminium foil.
Danger!
Is the bottom funnel "dirty", whereby the fats cannot drain off into the fat catcher tray? –
Clean the bottom funnel!
Appliance fire •
•
•
•
Notice:
Most fires in gas grills occur because fat and oil has accumulated or because the gas
connections have not been regularly and properly checked. Remember to follow the
manufacturer's instructions regarding cleaning and connecting the gas fittings.
Insects
Spiders and other insects may occasionally make cobwebs or nests in the burner pipes. This
may inhibit the flow of gas and cause a fire. This is known as flashback and can cause serious
damage to the gas grill and endanger the surrounding area. We recommend that the burner
pipes are regularly inspected and cleaned.
72
Turn off the gas cylinder.
Ventilate the area so that any accumulated gas can completely disperse.
Check all gas connections.
If there is a leak at the gas cylinder, remove it from the cabinet and place it upright in an
open area.
Keep well away from any gas or liquid escaping from the cylinder.
Keep the gas cylinder at least 20 metres away from sources of ignition, electrical
appliances, flashing lights, machinery, motors or engines.
Ensure maximum air circulation to allow the accumulated gas to disperse.
The ceramic surface is overloaded with drippings and deposits. Connections are blocked.
Burner overheats due to inadequate ventilation (the grill area is largely covered with
pans or pots).
Cracks or ruptures in the ceramic surface.
Sealing of ceramic surface is not airtight.
If a fire starts in the appliance, turn off the gas cylinder. Use a wet cloth to put out the
fire.
If the gas cylinder is on fire or if you cannot reach or turn off the switch, call the fire
service immediately.
Direct a garden hose at the centre of the gas cylinder to cool it down but never
extinguish the flames with water. As long as the gas is burning, it cannot form pools and
explode.
Evacuate the area.