Service; General; Maintenance Diagram General; Periodic Maintenance - Dibo IBH Mode D'emploi

E N
S E R V I C E

Service

GENERAL

All maintenance activities must happen at an disconnected machine and hoses
without pressure. Checking the electric components can happen exclusively
by an expert. Exclusively accessories and replacement components which have
been approved by the manufacturer can be used. Directly after the activities all
securities- and protection parts must be assembled, before the machine is put
in functioning. "a golden rule" that contributes to a perfectly working machine
with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the "know-how" of DiBO a technical good working machine is insured and
large maintenance turns can be carried out by experienced DiBO technicians
by means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1 General
The user can carry out only those actions for which in this book authorisation
are given. Each other act has been prohibited!
2

Periodic maintenance

OMSCHRIJVING
Control of the electric cables, high and low pressure
hoses and coupling and control of the oil level.
Refreshing pump oil.
Cleaning water filter.
Replacement fuel filters.
Cleaning fuel tanks.
All following refreshments of pump oil and services.
Extra control/replacement of joints, valves, o- rings
by acknowledged DiBO- technicians.
3

Control of oil level / refreshing of pump oil

Check for each use of the machine the oil via the oil level glass or with the oil
level bar. Oil must stand right with the sign of the oil level bar, if the this case is
not, oil tops up until the sign. If oil looks forward to there milky, consult directly
the DiBO technicians. To refresh oil, as follows work goes:
• Unbolt the drain plug below the pump.
• Unbolt the tap with the oil level bar. Catch all oil in a barge and remove oil.
• Force up the drain plug there and top up the oil in the breach to the upper
part to the exact level.
• Force up the tap with the oil level bar there.
• Recommended oil: 1.836.042
4 Cleaning of the water filters
Clean the water filters regular and remove possible dirt.
DiBO 24
PERIODE
After each use.
First 50 hours.
Each 50 hours/every
month.
First 50 hours, each
following 200 hours.
First 50 hours, each
following 200 hours.
Each 200 hours/half
yearly.
Each 600 hours.