6.2 Opening the base of the
product
To avoid scratching the product with the hexagonal
wrench, align the groove on the body of the product
with the screw before screwing it in.
Fig. 10
Unscrew the three screws at the bottom of the
product (Fig. 11, page 20).
Fig. 11
20
6.3 Mounting the bracket
Take special care when attaching and
fastening down the apparatus. If the
equipment must be fastened to a concrete
surface, plugs must be used with a
minimum traction force of 300dN each. For
a metal surface use screws with a diameter
of at least 8mm and of an appropriate
length. The fastening system must be
capable of supporting at least 4 times
the weight of the entire equipment (PTZ
camera, supports and adapters).
The device should be assembled vertically.
Any other position could impair the
performance of the device.
Various types of optional mounts and accessories are
available (9 Accessories and Supports, page 29).
Choose the mounting accessories for the installation
you want to implement (6.1 Installation options,
page 14).
Install the optional mounts and accessories by
following the instruction manuals provided with the
bracket or accessory.
MNVCEVO_2203_EN