• Assemble the upper body (6.12 Installation of the
upper body, page 27).
• Power the unit. Wait for 2 minutes.
• Disconnect the power supply to the unit.
• Open the base of the product (6.2 Opening the
base of the product, page 20).
• Reset DIP 1 of switch S1 OFF.
Fig. 31
• Assemble the upper body (6.12 Installation of the
upper body, page 27).
• Power the unit.
Once the factory default procedure has
finished, you need to configure the unit
as described in chapter: 8.1 Default IP
address, page 29.
MNVCEVO_2203_EN
12 Cleaning
12.1 Cleaning the window and
external surfaces of the product
Avoid ethyl alcohol, solvents,
hydrogenated hydrocarbide, strong acid
and alkali. Such products may irreparably
damage the surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
lenses.
S1
12.1.1 Cleaning the germanium window
When cleaning the window, take care not
to scratch or damage the outer surface
treated with carbon coating. Damage to
this coating could also interfere with the
transparency of the surface to infrared
light.
Cleaning should be done with mild soap diluted
with water.
31