Typical Connection Of Accessories - Videotec ULISSE EVO UE Manuel D'instructions

6.1.6 Typical connection of accessories

The figure displays how the accessories can be connected to the product.
Network
PC
ETH
VMS
Fig. 9
The power supply cables must be appropriately dimensioned. 0.75mm² (18AWG) or heavier wire is
recommended for most cable runs between the 24Vac/24Vdc power source and the camera (15 Technical
data, page 33). If a longer cable run is required, a wire gauge table should be consulted to ensure that the
voltage at the camera does not drop outside of the specified range when the camera is operating at the
maximum rated power draw.
The SURGEPR and FM1010 accessories must be installed close to the PTZ camera.
MNVCEVO_2203_EN
100m max
OHEP90INJ
ETH
OHEP90INJO
PSINJ95CH1
ETH 100m max
100Vac
120Vac
230Vac
WASPT
ETH 100m max or fiber optic
24Vac
120Vac-127Vac
220Vac-230Vac
WASPT
WASNX
24Vac
24Vdc
ULISSE
EVO
ETH
SURGEPR
UPTIRPS100N
24Vac
UPTIRPS120UL
UPTIRPS230
RL2A/RL2B
COMB100A
COMB200A
COMB300A
24Vac
RL2A/RL2B
100m max
ETH
ULISSE ULISSE
EVO EVO
24Vac
RL2A/RL2B
SURGEPR
FM1010
ULISSE
EVO
19