Information On Disposal And Recycling; Troubleshooting - Videotec ULISSE EVO UE Manuel D'instructions

13 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
32

14 Troubleshooting

Contact an authorised support centre if
the problems persist or you have any other
issues that are not described here.
PROBLEM The product does not go on.
CAUSE Cabling error.
SOLUTION Make sure the connections are
correct.
PROBLEM The product does not go
on. The LED indicated in the
figure is off (Fig. 25, page 27).
CAUSE Possible fault on fuse F3.
SOLUTION Contact the technical assistance
service (VIDEOTEC).
PROBLEM The shooting area do not
correspond to the selected
preset position.
CAUSE Loss of absolute position
reference point.
SOLUTION Reset the equipment by
switching off and on again.
PROBLEM With the PoE power supply,
the product blocks on the
"Maintenance" screen and
displays "Error 39".
CAUSE Possible unsuitable PoE injector
or DIP switch connector board
incorrectly configured.
SOLUTION Follow the instructions in the
chapter on the PoE power
supply (6.9.2.1 PoH backward
compatibility mode enabling,
page 25).
MNVCEVO_2203_EN