Maintenance; Firmware Updating; Factory Default; Information On Disposal And Recycling - Videotec MAXIMUS MVXHD Manuel D'instructions

Masquer les pouces Voir aussi pour MAXIMUS MVXHD:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50

8 Maintenance

The pre-installed camera can only be
replaced with one of the same brand and
model.
Read the product Manual A before
performing any operation.
Please provide the device serial number when
requesting any replacement parts.

8.1 Firmware updating

The H.264 encoder firmware can be
upgraded directly from the web interface.
If necessary, the device and video encoder firmwares
can be updated.
The firmware update operation can be performed
remotely (VIDEOTEC MACRO and PELCO D protocols
only) using a USB/485 Serial converter (not included
in the pack). This option is only available for the
analogue versions of the product.
For further information please contact the VIDEOTEC
service center.

8.1.1 Factory Default

It is possible to reset to the factory default settings.
Follow the procedure below:
• Power the unit. Wait for 2 minutes.
• Connect the signal cable grey and green wires (
Tab. 3, page 7).
• Wait for 2 minutes.
• Switch off the unit.
Disconnect the previously connected green and grey
wires.
• Power the unit.
In the default settings the device
is configured with the address
192.168.10.100.
20
9 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm .
For more information on proper disposal of these
devices, you can contact the responsible public
service.
MNVCMVXHDCAM_1813_EN

Publicité

Table des Matières
loading

Table des Matières