Network; Cybersecurity; Video; Video Analytics - Videotec ULISSE EVO UE Manuel D'instructions

Ethernet cable features
• Minimum cable features: Class D (ISO/
IEC11801:1995) or Category 5 (ANSI/EIA/TIA-
568-A:1995)
• Shielded twisted cable (STP)
• Pair: 4
• DC loop resistance: 25Ohm max
• Connector: Shielded RJ45

15.1.4 Network

Ethernet connection: 100 Base-TX

15.1.5 Cybersecurity

Digitally signed firmware
Password restricted access (HTTP digest)
Support of various user access levels
Control of accesses IEEE 802.1X
HTTPS cryptography using TLS1.0, TLS1.1, TLS1.2 and
TLS1.3
Centralised certificate management
Complies with ONVIF Security Service specifications

15.1.6 Video

Video encoder
• Communication protocol: ONVIF, Profile Q, Profile
S and Profile T
• Device configuration: TCP/IPv4-IPv6, UDP/IPv4-
IPv6, HTTP, HTTPS, NTP, DHCP, WS-DISCOVERY,
DSCP, IGMP (Multicast), SOAP, DNS
• Streaming: RTSP, RTCP, RTP/IPv4-IPv6, HTTP,
Multicast
• Video compression: H.264/AVC, MJPEG, MPEG4,
snapshot JPEG
• 3 independent video streams Full HD
• Image resolution: from 320x180pixel up to
1920x1080pixel in 8 steps
• Selectable frame rate from 1 to 60 images per
second (fps)
• Web Server
• Directional OSD (maximum 4 settable areas)
• Motion Detection
• Video analytics: VIDEOTEC ANALYTICS (optional)
• QoS: Differentiated DSCPs for streaming and
device management
• SNMP and NTCIP protocols
34

15.1.7 Video analytics

Ultra-robust detection algorithms and auto-tracking,
specifically for outdoor perimeter control.
Targets Classification: People, vehicles, generic
objects
Programmable rules for video analysis, VIDEOTEC
ANALYTICS (it is possible to rapidly configure up to
ten rules for every preset using an intuitive control
management interface)
• Line crossing: the target triggers an alarm if it
crosses the line in one or both directions
• Entering/leaving area: the target triggers an
alarm if it leaves or enters the configured area
• Appearing in area: the target triggers an alarm if
it appears inside the configured area
• Loitering: the target triggers an alarm if it stays
inside the configured area over the set time
Detection Mask: disables the detection activity in a
portion of the image to prevent false alarms
Video Tampering Detection: a specific ONVIF alarm
is triggered if the video camera view is obstructed
(e.g. spray)
MNVCEVO_2203_EN