Table des Matières
Publicité
HANDLEBAR
11. Install:
• Engine stop switch 1
• Clutch lever holder 2
• Bolt (clutch lever holder) 3
• Hot starter lever holder 4
• Bolt (hot starter lever holder) 5
• Clamp 6
NOTE:
• The engine stop switch, clutch lever holder
and clamp should be installed according to
the dimensions shown.
• Pass the engine stop switch lead in the mid-
dle of the clutch lever holder.
12. Install:
• Clutch cable 1
• Hot starter cable 2
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
13. Adjust:
• Clutch lever free play
Refer to "CLUTCH ADJUSTMENT" sec-
tion in the CHAPTER 3.
• Hot starter lever free play
Refer
to
ADJUSTMENT" section in the CHAPTER
3.
5 - 48
CHAS
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
"HOT
STARTER
LEVER
Publicité
Table des Matières
