Table des Matières
Publicité
REAR SHOCK ABSORBER REBOUND
DAMPING FORCE ADJUSTMENT
5. Tighten:
• Locknut
6. Install:
• Rear frame
EC36N014
REAR SHOCK ABSORBER REBOUND
DAMPING FORCE ADJUSTMENT
1. Adjust:
• Rebound damping force
By turning the adjuster 1.
Stiffer a → Increase the rebound damp-
ing force. (Turn the adjuster 1 in.)
Softer b → Decrease the rebound damp-
ing force. (Turn the adjuster 1 out.)
Extent of adjustment
Maximum
Fully turned in
position
• STANDARD POSITION:
This is the position which is back by the spe-
cific number of clicks from the fully turned-in
position. (Which align the punch mark a on
the adjuster with the punch mark b on the
bracket.)
Standard position:
About 6 clicks out
* About 8 clicks out
* For EUROPE
CAUTION:
Do not force the adjuster past the minimum
or maximum extent of adjustment. The
adjuster may be damaged.
3 - 37
INSP
ADJ
32 Nm (3.2 m · kg, 23 ft · lb)
Minimum
20 clicks out
(from maximum
position)
Publicité
Table des Matières
