Step 1 Remove Upper Enclosure; Step 2 Remove Door - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Reversing the Door Swing
WARNING
Follow all steps when reversing the
door swing. Failure to follow these instructions, leaving
off parts, or overtightening screws, can lead to the door
falling off and result in injury and property damage.
If installation will require the door swing to be reversed,
follow these directions to reverse the door swing
BEFORE the unit is removed from the shipping skid.
Instructions for reversing a RH swing refrigerator are
shown in the following steps.
WARNING
This appliance is top heavy, especially with the door
open, and must be secured to prevent tipping forward
which could result in death or serious injury.
STEP 1 REMOVE UPPER
ENCLOSURE
Open the front cover of
the enclosure to 90°.
Locate filter and filter
removal tool. Filter
should be as shown.
counterclockwise
needed).
remove. NOTE: Water
Remove 6 screws securing front enclosure to top case.
31-1000190 Rev. 2
Tip Over Hazard.
Compartment Door
Filter
Mounting
Hook
Filter Removal Tool
1/4" Hex Screws

STEP 2 REMOVE DOOR

Open the door to the open position.
Have a second person support the open door.
Remove 2 T30 Torx screws securing the bottom
hinge to the case.
Remove the 2 T30 Torx screws securing the top
hinge to the case.
Place the door on a protected work surface (to
prevent scratches), liner side down.
NOTICE: Door hinges will remain in the open position
during the door reversal procedure.
WARNING
Point Hazard
Door hinges are under tension and should be left in the
open position throughout the reversal process. Closing
the hinge can lead to a finger pinch point hazard.
7
Screws
Screws
Door Hinge Pinch