Step 10 Toe Kick Installation; Step 11 Internal Unit Preparation; Step 12 Start Icemaker - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Dual Retro-Fit Installation

STEP 10 TOE KICK INSTALLATION

Insert Toe Kick into the slot in the Front Access
Cover by rotating it toward you.
Push the bottom
portion of the Toe
Kick towards the
product and slide
into place.
STEP 11 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from each unit
(foam shipping supports may be located behind the
left and right sides of each of the glass pan fronts on
Refrigerator models).
Remove boxed door bins from shelves.
Unbox and install door bins.
Install door bin mats.

STEP 12 START ICEMAKER

(freezer models)
CAUTION
injury, avoid contact with the moving parts of the
ejector mechanism, or with the heating element that
releases the cubes. Do not place fingers or hands on
the automatic ice making mechanism while the
appliance is plugged in.
A newly-installed freezer may take 12–24 hours to
begin making ice.
The icemaker will produce seven cubes per cycle—
approximately 15 cycles in a 24-hour period,
depending on freezer compartment temperature, room
temperature, number of door openings and other use
conditions.
If the freezer is operated before the water connection
is made to the icemaker, set the power switch to
OFF. Top wire basket must be removed to access the
icemaker power switch.
When the freezer has been connected to the water
supply, set the power switch to ON.
Throw away the first full bucket of ice to allow the water
line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
(Appearance may vary)
Feeler Arm
Power
Switch
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.
36
To minimize the risk of personal
Icemaker
Icemaker
Feeler Arm
Power
Switch
31-1000190 Rev. 2