Step 9 Final External Unit Preparation - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is 7/8" behind front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Open the doors to
the units. Locate
removal tool. Filter
should be as shown.
counterclockwise
tool if needed).
remove. NOTE: Water
system will not function
Make sure lights are on inside the unit. If they are not
on, check to make sure the master switch is on by
removing the front enclosure which is secured with
six 1/4" Hex screws.
Switch on the master switch if not on. (Master Switch
Wires hidden for clarity.
Assemble the enclosure with removed screws.
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
Secure unit by driving four 1/4" hex screws to both
sides to surrounding cabinetry. NOTE: This step
does NOT replace the anti-tip safety hardware. Refer
to Step 4 Installing Anti-Tip Bracket and Step 7
Inserting/Securing into Cabinet Surround for details
on installing the anti-tip hardware. Repeat for the
second unit.
31-1000190 Rev. 2
Make sure front surface
Compartment Door
Filter
Mounting
Hook
Filter Removal Tool
1/4" Hex Screws
Master Switch
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Locate blue arrow on
align arrow as shown.
removal tool if needed).
mounting hook.
Close the compartment door.
Verify the two 1/4" hex head
screws are assembled to handle
side of the products for both
freezer and fresh food columns.
1/4" Hex Screws
Put the access cover back onto the unit and secure
with two 1/4" hex head screws.
Access
Cover
21
1/4" Hex Screws
1/4" Hex
Screws