Monogram ZIR241NPNII Instructions D'installation page 35

Installation Instructions - Dual Retro-Fit Installation
STEP 9 FINAL EXTERNAL UNIT PREPARATION (Cont.)
For proper case placement after leveling, the back side
of the top and side retro trims should be flush with the
cabinet surround on all sides.
Refrigerator
or Freezer
Retro Trim
Secure the trims to the surrounding cabinets to reduce
excess movement to the top of the case during normal
operation.
2 on
each
side
1. Drill 1/16" pilot holes in the trim 1/2" deep(2 per side,
see figure for approximate locations).
2. Drive #6 Phillips head wood screws into the pilot
holes.
NOTE: This step does NOT replace the anti-tip safety
hardware. Refer to Step 4 Installing Anti-Tip Bracket
and Step 7 Inserting/Securing into Cabinet Surround for
details on installing the anti-tip hardware. Repeat for the
second unit.
Verify the two 1/4" hex head screws are assembled to
handle side of the products for both freezer and fresh
food columns.
1/4" Hex Screws
31-1000190 Rev. 2
Cabinet
Surround
Put the access cover back onto the unit and secure with
two 1/4" hex head screws.
Access
Cover
Install front mullion and access cover trims between
the 2 units. Open the doors and push the flexible "dart"
area of the trims in place between units.
Top dart of the mullion must align with bottom edge of
the case trim.
Open both enclosure doors to 90°.
Snap the trim to hinge assemblies of both enclosures.
Trim
35
1/4" Hex
Screws
Upper Mullion
Trim
"Dart"