Step 5 Reinstall Hinge Brackets; Step 6 Reinstall The Enclosure - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Reversing the Door Swing
STEP 4 MOVE LIGHT SWITCH
HOUSING (Cont.)
Move the mounting bracket to the other side of the
unit by removing two Philips screws and using them
to install the bracket in its new location.
Mounting
Bracket and
Screws
Slide housing forward and down to remove from case
and grommets on case bottom.
Keeping it connected to the unit, lay housing aside.
Grommets
Remove 2 grommets with Phillips driver.
Move grommets to the set of 2 holes on opposite
side.
Align housing key holes over grommets and then
slide back until engaged. Ensure wires do not get
pinched.
Housing Key Holes
Install Phillips screw into bottom hole to hold in place.
31-1000190 Rev. 2
STEP 5 REINSTALL HINGE
BRACKETS
Move top hinge bracket to bottom and bottom bracket
to top.
Ensure the 2 rectangular slots of bracket are on
outside, hinge side of case.
Rectangular
Slots
Install both brackets with 3 T-30 Torx screws 45 in/lb
(5.1 Nm).
Phillips Screw
Install the Phillips screw.
Start 2 screws in
each bracket for
hinge mounting
but do not tighten
all the way.
STEP 6 REINSTALL THE
ENCLOSURE
Install the enclosure assembly with removed six 1/4"
hex head screws.
Locate blue arrow on filter. Rotate filter to align arrow
as shown.
9
Screws for
Hinge Brackets
1/4" Hex Screws