Step 7 Inserting/Securing Into Cabinet Surround - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Dual Retro-Fit Installation

STEP 7 INSERTING/SECURING INTO CABINET SURROUND

Plug both units to the outlet in the wall.
WARNING
To reduce the risk of electrical shock, be careful
during the remaining installation steps not to
touch wiring or electrical components inside the
compressor compartment while the appliance is
plugged in and the front access cover is not in
place.
Find the installation string that is attached to the door
of the unit; this is to be used as you are pushing the
unit back into the opening. The string is attached to the
power cord; as you walk the unit back into the opening
you should pull the string tight to make sure the power
cord is routed underneath the unit.
Installation
String
Slowly walk both units into opening making sure not
to touch the cabinetry on the sides and top to prevent
damage. The back side of the top and side retro trims
should be touching the cabinet surround when the
units are pushed back.
Refrigerator
or Freezer
Retro Trim
WARNING
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
31-1000190 Rev. 2
Electrical Shock Hazard.
Cabinet
Surround
Tip Over Hazard.
Place power cord on its edge and pull under product
between rollers and away from the anti-tip bracket to
ensure cord is not damaged during installation.
As you walk the unit back into the opening, you should
pull the string tight to make sure the power cord is rout-
ed underneath the unit.
String
Replace the waterline strain relief screw.
Strain Relief
Screw
Store the excess strapping, string, and water tubing
under the unit.
WARNING
Replace waterline strain relief in front rail location as
shown.
33
Power Cord
Electrical Shock Hazard.