Step 4 Install Hinge Covers; Step 5 Install Door Trims - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Custom Overlay Door Panel
STEP 3 ADJUST OVERLAY PANEL
(Cont.)
After the panel has been adjusted to the desired
position, secure the panel by first driving and
tightening the vertical screws at the bottom of the door
brackets and then drive and tighten the remaining
horizontal screws. ALL 12 SET SCREWS should be
driven and firmly tightened in order to properly secure
the panel.
After the top
and bottom door
panel brackets
are secured
Square
by installing /
Washer
tightening all 12
set screws, use
1/4" hex screw
and square
washer to secure
the center
mounting bracket.

STEP 4 INSTALL HINGE COVERS

Replace the top and bottom hinge covers using
4-T30 screws per cover.
Top Hinge
Cover
Bottom
Hinge
Cover
31-1000190 Rev. 2
Center
Mounting
Bracket
1/4" Hex Screw
T30 Torx
Screws
T30 Torx
Screws

STEP 5 INSTALL DOOR TRIMS

There are 2 door trims to install. One for the handle
side and one for the hinge side. The long trim is for the
handle side and the shorter trim is for the hinge side.
Install the handle side trim first.
Clean the side of the door, including the
side of the top and bottom hinge covers
with rubbing alcohol to improve trim
adhesion.
The side trim is made up of an outer trim
and an inner trim. Adjustments need to be
made before adhering to the side of the
door. Without removing the backing to the
tape strips, test the fit of the trim to the
side of the door.
1. Align the top of the outer trim to the top of the door
panel
2. Inner trim should fit between the top and bottom
hinge covers
3. Make sure outer trim is setting flush against the
back of the door panel
4. Adjust the inner trim until it is flush against the
back of the door by pushing into the outer trim.
2
4
Push to
adjust
Once the test fit is
complete, remove
the trim and peel
8-10" of backer off
of the top of the
inner trim tape.
55
1
P
a
n
e
l
3
Door
Panel
Outer
Trim
Inner
Trim