Step 4 Install Anti-Tip Bracket - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Dual Retro-Fit Installation

STEP 4 INSTALL ANTI-TIP BRACKET

WARNING
These appliances are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or seri-
ous injury. Read and follow the entire installation
instructions for securing the appliance with the
anti-tip system.
Remove the anti-tip bracket from the hardware kit.
Anti-tip bracket should be mounted against the back
wall or up to 27" (68.6 cm) maximum from front of
opening. Use floor mounting method if the bracket is
not against a wall (bracket hardware is provided for
mounting into wood, steel studs and concrete).
LH Unit
18" 24"
26-5/8" 23-1/2'
67.6 CM 59.6 CM
32-5/8" 29-1/2"
67.6 CM 59.7 CM
38-5/8" 35-1/2"
67.6 CM 59.7 CM
Measure and mark from the LH side of the opening per
the table above depending on the size of the LH unit
you are installing.
Measure and mark again from the RH side of
the opening per the table and depending on your
combination of LH and RH units.
For example, if installing an 18" LH unit and a 30" RH
unit, use 5-3/4" and 38-5/8".
31-1000190 Rev. 2
Tip Over Hazard.
RH UNIT
30"
23-1/2" 8-7/8"
18"
59.7 CM 22.5 CM
29-1/2" 5-3/4"
24
59.7 CM 22.5 CM
35-1/2" 5-3/4"
30
59.7 CM 22.5 CM
RH Unit
LH Unit
Mount the anti-tip bracket centered about the marks
and flush to the floor as shown. Mark 3 holes for wall
mounting or 4 holes for floor mounting.
WOOD MOUNTING: Predrill with 3/16" drill bit, 2" deep,
then install lag bolts with a 7/16" driver.
CONCRETE MOUNTING: Predrill with a 5/32" concrete
bit, 2" deep, then install tapcon screws with a 7/16"
driver.
STEEL MOUNTING: Predrill with a 1/2"
drill bit, insert toggle, then install bolts
with a 7/16" driver.
The bracket must be screwed to either
the FLOOR or REAR WALL.
If the enclosure is deeper than 25 ½", the anti-tip
bracket should be secured to the floor 25" from front of
the enclosure.
Tape the waterline to the floor approximately 3" to the
left of the anti-tip bracket. Apply tape about every 5"
toward the front of the opening (tape will prevent the
unit from rolling over the waterline during installation).
Do not tape near the cabinet front in order to keep tape
hidden under the unit.
3"
5"
29
3"
5"
Anti-tip Brackets