Monogram ZIR241NPNII Instructions D'installation page 31

Installation Instructions - Dual Retro-Fit Installation
STEP 5 JOINING DUAL INSTALLED UNITS (Cont.)
CHANGE POWER CORD
Longer power cords are required for retro fit installation.
Power cords are included in 42" ZKR42N and 48" ZKR48N.
Replace power cords on both units. Both units can be
plugged into the same electrical supply receptacle.
Remove existing short power cord with string
assembly:
Remove 1/4" hex screws attaching rear access cover.
1. Unplug 3-pin power cord connector inside the
machine compartment (press on sides to release
locking tabs).
2. Remove power cord green ground 1/4" hex screw.
3. Remove strain relief 1/4" hex screw.
Step 2
Green Ground
Screw
Step 3
Strain Relief
Screw
Install new longer power cord:
1. Plug in the 3-pin connector (make sure locking tabs
are engaged).
2. Install the power cord green ground screw.
3. Install the power cord strain relief.
WARNING
To avoid the risk of electric shock, make sure to re-install
the ground screw after changing the power cord.
Replace rear access cover. Make sure the power
cord and ground wire are properly routed through the
access cover cut-out.
Repeat all steps for second unit.
Step 3
31-1000190 Rev. 2
Step 1
3-Pin
Power Cord
Connector
3-Pin
Power Cord
Connector
Rear
Access
Cover
Electrical Shock Hazard.
Step 2
Ground
Wire
Power
Cord
CASE TRIM INSTALLATION
Install the trim kit side rails to the exposed right and left
case walls using the provided #8 Phillips head screws -
7 screws per side.
Pre-assemble the trim kit top rail and corner keys. One
corner key should be installed to each end of the top
trim. Use the provided #6 Phillips head screw in the
corner key to ensure that the key is snugly fit to the
top trim, but be sure not to overtighten the screw to
prevent damage to the parts.
31
Corner Key