Monogram ZIR241NPNII Instructions D'installation page 56

Installation Instructions - Custom Overlay Door Panel
STEP 5 INSTALL DOOR TRIMS
(cont.)
Without touching the exposed
tape to the side of the door,
align the top of the trim with
the top of the door panel. (tape
backer should be sticking out
when aligning the trim).
Once the trim is in location
(aligned to the top of the door,
hinge covers, tight to the door
and door panel), then push
on the exposed tape area to
secure. Slowly start pulling the
tape backer off and pushing to
adhere the tape while keeping
the trim in place until you have
completely removed the tape
backing.
Secure the top and bottom portions of the outer trim
after the inner trim has been secured.
1. Gently pull the top of the outer trim away from the
door panel in order to expose the tape backer.
Do not bend too far away from the door or trim
damage may occur.
2. Peel the backer off the outer trim tape and press
to secure the trim.
3. Repeat for the bottom of the outer trim.
Once the handle side door trim is in place, repeat the
same steps for the hinge side door trim.
56 31-1000190 Rev. 2