Step 1 Install Stainless Panel; Step 2 Adjust Stainless Panel - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Stainless Door Panel
Stainless Steel Door Panel Kits are available with either
Euro handles or Pro handles.
ZK1SN189NLH LH 18" Stainless Steel Door Panel
ZK1SN184NRH RH 18" Stainless Steel Door Panel
ZK1SN249NLH LH 24" Stainless Steel Door Panel
ZK1SN244NRH RH 24" Stainless Steel Door Panel
ZK1SN309NLH LH 30" Stainless Steel Door Panel
ZK1SN304NRH RH 30" Stainless Steel Door Panel
ZKSP1H1CNSS Minimalist Handle for Stainless
Steel Panels Only
ZKSP1H1PNSS Statement Handle for Stainless
Steel Panels Only
Stainless steel panel is fully assembled with brackets
and handle already installed
LH door kits can be modified to fit RH swing units and
RH door kits can be modified to fit LH swing units.
Leave the protective film on the door until the
installation is complete.
WARNING
Door Trim Pinch
Point Hazard
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly, and
door stop angle.
as a LH or RH swing door.

STEP 1 INSTALL STAINLESS PANEL

Remove bottom hinge cover and retain the 4 T30
Torx screws for later installation.
Open door to 90°. Slide the
panel onto the door with the
panel brackets interlocking
on top and bottom with the
door brackets (make sure
not to slide the panel into
the cabinetry surround).
Center the panel on the
door, then slowly close
the door while watching to
make sure the panel does
not contact the surrounding
cabinetry.
With the door fully closed,
carefully slide the panel towards
the cabinetry with the goal gap
of 1/8".

STEP 2 ADJUST STAINLESS PANEL

Door adjustments will be
made with 12 set screws
provided. Each corner
of the door will use 3
adjustment set screws.
Use a 1/8" allen wrench
to install the set screws in
the order as instructed.
The set screws behind
the top and bottom
support brackets are
partially hidden.
48
T30 Torx
screws
Bottom
hinge
cover
Panel
Bracket
Door
Bracket
Overlay Cabintery
Panel Surround
1/8" gap
Set
Screws
Hidden Set
Screw
Set
Screws
31-1000190 Rev. 2
Panel