Step 5 Joining Dual Installed Units - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Dual Integrated Installation

STEP 5 JOINING DUAL INSTALLED UNITS

BOTTOM BACK UNIFICATION
Loosen the two bottom screws of rear access covers of
both units and remove the top screws.
Hang the unification bracket to the bottom screws and
reassemble the screws at the top
Tighten screws to tie units together.
BOTTOM FRONT UNIFICATION
Install the bottom front unification bracket using a 3/8"
driver (4 screws).
TOP UNIFICATION
Bracket
18
Loosen the front two screws on top of the unit and
remove the two middle screws.
Assemble the bracket to the front screws and reinstall
the middle screws.
Tighten screws to tie units together.
Bracket
31-1000190 Rev. 2