Step 9 Panel Brackets And Hinges; Step 10 Reinstall The Door - Monogram ZIR241NPNII Instructions D'installation

Installation Instructions - Reversing the Door Swing
STEP 9 PANEL BRACKETS AND
HINGES
Remove panel brackets on each end of the door by
removing the T30 Torx screws.
Slide same bracket on each end to other side of door
and re-install brackets to door.
Install hinges to door ensuring that 2 shims are
between hinge L-bracket and door. Install with 3 T-30
Torx screws 45 in/lb (5.1 Nm)
Shims
Hinge
NOTE: Ensure L-bracket remains attached to hinge
and is on the outer side of the door. Hinge is on the
inner door side.
REMINDER: Hinges have to move from top to bottom
and bottom to top.
Install support bracket screw through both support
bracket and panel bracket.
31-1000190 Rev. 2
Support
Bracket

STEP 10 REINSTALL THE DOOR

WARNING
Follow all steps when reversing
the door swing. Failure to follow these instructions,
leaving off parts, or overtightening screws, can
lead to the door falling off and result in injury and
property damage.
Ensure 2 hinge screws are started but not tightened
in hinge brackets on case.
With 2nd person, hold door with hinges near correct
position.
Install top hinges with key hole over screws and slide
bracket.
Key hole slot
over screws
Repeat on bottom.
NOTE: Ensure 2 tabs on hinges are inserted into
the rectangular slots on outside of hinge brackets
BEFORE tightening screws.
Tighten bottom screws 45 in/lb (5.1 Nm).
Tighten top screws 45 in/lb (5.1 Nm).
Carefully ensure door closes correctly and gasket
aligns with case.
11
Tabs in
rectangular slots