Table des Matières
Publicité
Pressure sensors
149
Standard specification
Reference
Calibration
Temperature effects
Zero error compensation
Overpressure
Pressure containment
Recalibration
Warm uptime
Operating temperature range
Relative Humidity
User terminals (electrical)
Interconnecting plugs
Protection
Size
Pressure readings (selectable)
Selectable CLD-II source readings
Selectable CLD-II measure readings
Media compatibility
Electrical interface
Pressure connection
Specifications subject to change without notice
Horizontal positioned sensor(s) 22
(absolute sensors vertical positioned)
Traceable to National Standards
+0.5% F.S. T.E.B. over 0-50
0
C
typically 0.015% F.S./
0
C
Manual reset on CLD-II calibrator
2x pressure range up to 140 bar max. for ranges 120 bar & lower
3x pressure range up to 200 bar max. for ranges 120 bar & above
2x pressure range up to 1000 bar max. for ranges 120 bar & lower
3x pressure range up to 1400 bar max. for ranges 120 bar & above
Recommended for each 12 to 14 months
15 minutes for rated accuracies
- 10
0
C to 40
0
C (-14
0
F to 104
0
F)
0-90% non-condensing
Gold plated for standard 4 mm plugs
Gold plated 2 mm and 4 mm plugs
IP 66
70 x 25 mm (2.8 x 1 inch)
kPa, mbar, psi, inHg, inH
O, mmH
2
Pressure sensor + all standard CLD-II source functions
Pressure
Milliamps
Switch
Fluids compatible with stainless steel 316L and Hastelloy C276
LEMO connector (4 pin)
G¼ female with ¼ NPT male and G¼ 13 flatmale adaptor and bonded seal
0
0
C ±1 (72
F +2), RH 45% ±15
O ,ftH
O, mmHg, kgf/cm
2
and atm
2
2
Publicité
Table des Matières
