EUROTEAM WALKER700CDP Manuel D'utilisation page 109

Linear Pull Brakes
After installing the front wheel, re-connect the front brake by squeezing the arms
together, and sliding the cable guide back into the carrier (see Figures 30 & 31).
Disc Brakes
When installed properly, the disc brake rotor should be centered between the brake pads, and securely fastened to
the wheel (see Figure 32). Use (C) a 4, 5, or 6 mm Allen Wrench to check the rotor mounting bolts to ensure that none
of the bolts are loose. To tighten the brake cable, loosen the cable anchor bolt, pull the cable taught, and re-tighten
the bolt (see Figure 33).
Ensure that the mounting bolts on Disc Brake are evenly tightened (see Figure 33). If not, the Disc Brakes will be out
of alignment with the Rotor, and you will not be able to brake efficiently or safely.
NOTE: If your bike is equipped with a disc brake, make sure that the disc rotor slides easily into the brake caliper when
installing the front wheel.
DO NOT pull on the lever before the wheel is installed. It may cause the brake pads to bind together and it is difficult to
separate them without the proper tools and expertise.
Figure 30
Cable Carrie Brake cable
Cable
Anchor Nut
Brake arm
Brake pad
Figure 31
Figure 32
Figure 33 108