EUROTEAM WALKER700CDP Manuel D'utilisation page 106

The stem should be pointing towards the front of the bike, aligned with
the front tire (see Figure 16). Depending on the type of bolt, tighten the
stem bolt with either (B) an adjustable wrench or (C) a 4, 5, or 6 mm
Allen wrench (see Figure 17).
If your bicycle comes with a threadless stem (see Figure 18), we must
first remove the headset in order to install. Use (C) a 4, 5, or 6 mm Allen
wrench to remove the preload bolt, cap and cardboard spacer from the
headset. Discard the cardboard spacer (see Figure 20).
Loosen the bolts on the side of the stem, slide the stem into place, making
sure it lines up with the fork (see Figure 16). Check the gap between the
steerer tube and stem, ensuring there is enough space to reinstall the
cap and bolt. (See Figure 19) If you need it higher or lower, your local
bike mechanic can help you out with the adjustment. Snug the pre-load
bolt on top. Then tighten the two bolts on the side of the stem, alternating
each bolt.
Figure 16
Figure 17
Figure 18 Figure 19
Pre-Load
Bolt
Top Cap
Stem
Spacer
Bearing
Spacer
Cup
Figure 20
105