Front Wheel - EUROTEAM WALKER700CDP Manuel D'utilisation

FRONT WHEEL

Before installing the front wheel, ensure that the brakes are opened enough to allow the tire to fit through them.
On side-pull equipped bikes, you may have to loosen the cable anchor bolt (see Figure 29) in order to allow the
tire to fit through. On Linear Brake equipped bikes, squeeze the brake arms together by hand, and lift the cable
out of the carrier to open up the brakes (see Figure 31).
To install the front wheel, insert the wheel in the dropouts, place the locking washer on the axle, line up the tab
on the retainer clip with the corresponding hole in the drop out. Place the locknut on the axle after the retainer
clip and tighten the lock nut with (B) Adjustable Wrench (see Figures 26 & 27).
WARNING: Put the wheel in the center of the fork and tighten both nuts.
WARNING: Failure to obey these steps can allow the front wheel to loosen or dislodge while riding.
This can cause injury or death to the rider or to others.
BRAKES
WARNING: When assembling or adjusting the brakes, make sure the cable anchor nut is tight.
Failure to securely tighten the nut could result in brake failure and personal injury (see Figure 29).
SIDE PULL BRAKES
After installing the front wheel, loosen the cable anchor nut and pull the brake cable through it. Squeeze
the brake arms together against the rim of the wheel. While still holding the brake arms, pull the cable
firmly through the cable anchor nut and tighten the nut securely (see Figures 28 & 29). To fine tune your
brakes, see the adjustment section on pages 115-117.
Figure 26
Drop-out
Retainer Clip
Locknut
Figure 27
Figure 28
Cable Anchor
Bolt
Brake
arm
Brake
pad
Brake
cable
Figure 29
107