MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 15

12
ITEM(S) NEEDED
#2 x 3
NOTE: To prevent seizing of the stainless steel
hardware, do not use high speed installation
tools. Wetting the screws or applying an anti-
seize may help prevent seizing.
s. Place the hardware on the Damper side of the
mount into the Mounting Holes to secure the
Base Extrusion.
t. If installing with a Quick Release Bracket,
install the motor with the Hex Head Bolts (Item
#3) and Clipped Washers (Item #4). Orientate
the Clipped Washers so that the flat side of the
washer is towards the Base Extrusion. The Bolt
should pass through the Clipped Washer, Base
Extrusion and into a Quick Release Bracket.
NOTE:
The Long Bolts, Flat Washers and
Nylock Nut are not used when installing the
Riptide Ulterra with a Quick Release Bracket.
u. If installing directly to the boat deck, install
the motor with the Long Bolts (Item #2), Clipped
Washer (Item #4), Flat Washer (Item #5) and
Nylock Nut (Item #6). Orientate the Clipped
Washers so that the flat side of the washer is
towards the Base Extrusion. The Bolt should pass
through the Clipped Washer, the Base Extrusion,
the Rubber Washer and then through the Boat
Deck. The Bolt should be secured by first adding
the Flat Washer (Item #5) and then securing with
a Nylock Nut (Item #6).
NOTE: The Short Bolts are not used when
installing the Riptide Ulterra directly to the boat.
©2016 Johnson Outdoors Marine Electronics, Inc.
#5 x 3 #4 x 3
12s
12t
Mounting
12u
INSTALLING THE RIPTIDE ULTERRA
#6 x 3
CAUTION
Use extra care to avoid pinching and damaging the sensor
wires that run along side of the Base Extrusion when installing
and tightening the motor mounting bolts.
Mounting Holes
Hex Head Bolt
Clipped
Washer
Holes
Quick Release Bracket
Long Bolts
Clipped
Washer
Rubber
Washer
Flat Washer
Nylock Nut
Mounting Holes
#3 x 3
Boat Deck
minnkotamotors.com | 11