MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 13

8
m. Mount the motor to the boat using the provided
hardware. Place the installation hardware for the
side of the mount where the Power Tilt is located
first. This is the opposite side of the mount from
where the Extension Damper was removed. The
base of the Mount where the Power Tilt is located
has Mounting Slots and the side where the
Extension Damper is located has Mounting Holes.
9
ITEM(S) NEEDED
#2 x 3
NOTE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation
tools. Wetting the screws or applying an anti-
seize may help prevent seizing.
n. If installing with a Quick Release Bracket,
install the motor with the Hex Head Bolts (Item
#3) and Clipped Washers (Item #4). Orientate
the Clipped Washers so that the flat side of the
washer is towards the Base Extrusion. The Bolt
should pass through the Clipped Washer and
into a Quick Release Bracket. Leave at least 1/4"
space between the Hex Head Bolt and Clipped
Washer in order to slide the Base Extrusion under
the Clipped Washer and into place.
NOTE:
The Long Bolts, Flat Washers and
Nylock Nut are not used when installing the
Riptide Ulterra with a Quick Release Bracket.
©2016 Johnson Outdoors Marine Electronics, Inc.
#5 x 3 #4 x 3
9n
INSTALLING THE RIPTIDE ULTERRA
Power Tilt
Mounting Slots
#6 x 3
Hex Head Bolt
Clipped
Washer
CAUTION
Use extra care to avoid pinching and damaging the sensor
wires that run along side of the Base Extrusion when installing
and tightening the motor mounting bolts.
#3 x 3
Quick Release Bracket
minnkotamotors.com | 9