MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 18

INSTALLING THE PROP
Installing the Prop
1
ITEM(S) NEEDED
#17 x 1
CAUTION
Disconnect the motor from the battery before beginning
any prop work.
a. Take the Drive Pin (Item #18) and slide it through
the Hole in the Armature Shaft. Position the
Drive Pin horizontal by grasping the Armature
Shaft and rotating it with the Drive Pin in place.
b. Align the Propeller (Item #17) so it is also
horizontal and parallel with the Drive Pin. Slide
the Propeller onto the Armature Shaft and Drive
Pin until it is seated against the lower unit.
c. Install the Prop Washer (Item #19) and the Anode
(Item #20) onto the end of the Armature Shaft.
d. Holding the end of the Armature Shaft with a
Flat Blade Screwdriver, tighten the Anode with a
9/16" Open End Wrench.
e. Tighten the Anode 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Do not over tighten as this can damage the prop.
14 | minnkotamotors.com
#19 x 1
#20 x 1 #18 x 1
1a
Drive Pin
Prop Washer
1b
1d
Anode
Prop Washer
Propeller
Armature Shaft
Propeller
Anode
Propeller
Drive Pin
©2016 Johnson Outdoors Marine Electronics, Inc.