MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 11

3
e. Under the Left Sideplate, the Extension Damper
obstructs access to the left front Mounting Hole.
f. Using a small Screw Driver, remove the two
5/16" E-clips holding the Extension Damper in
place. Once the E-clips are removed, slide the
Extension Damper off the Mount to expose the
left front Mounting Hole. Set the two E-clips and
Extension Damper in a safe place so they are not
misplaced before they are reassembled later in
the installation.
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor
before it is mounted to the boat may cause injury.
4
g. Make sure the Power Cables from the battery
are disconnected, or that the breaker, if equipped,
is "off".
WARNING
Make sure the motor is mounted on a level surface and is not
connected to a power source.
5
h. Place the motor on the bow of the boat. Place
the motor as close to the centerline or keel of
the boat as possible. The motor can be installed
on either the Port or Starboard side of the boat
based on personal preference. Reviewing the
mounting considerations at the beginning of the
installation section.
NOTE: The Emergency Strap (Item #9) is used
for Manually Stowing the Ulterra. The Emergency
Strap is not secured during installation. Store it
on your boat in the event that you would need
to manually stow the motor. To learn how, please
refer to the "Manually Stowing the Ulterra"
section of the Owner's Manual.
©2016 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE RIPTIDE ULTERRA
3e
E-clip
Extension Damper
3f
E-clips
Power Cables
Mount
Keel
Mounting Hole
E-clip
Extension Damper
Deck of Boat
minnkotamotors.com | 7