MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 10

INSTALLING THE RIPTIDE ULTERRA
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the keel or centerline of
the boat as possible. Make sure the area under the mounting location is clear to drill
holes and install nuts and washers. Make sure the motor rest is positioned far enough
beyond the edge of the boat. The motor must not encounter any obstructions as it is
lowered into the water or raised into the boat when stowed and deployed. Consider
a quick release or adapter bracket with the installation of your motor. To view a list of
accessories, please visit minnkotamotors.com.
TOOLS AND RESOURCES REQUIRED
• #2 Phillips Screwdriver
• #3 Phillips Screwdriver
INSTALLATION
Installing the Riptide Ulterra
1
a. Place the mount on an elevated, level surface
such as a workbench or the tailgate of a pickup.
The motor, as removed from the box, should be in
the stowed position.
b. Remove the four sideplate screws using a #3 or
#2 Phillips screwdriver. Two of these screws will
be located on each side of the mount.
Deployed
2
c. Remove the Right Sideplate to access the
Mounting Slots.
d. Remove the Left Sideplate to access the
Mounting Holes.
6 | minnkotamotors.com
• Drill
• 9/32" Drill Bit
Stowed
• A person to help with
installation
1b
Right
Sideplate
Screw
Screw
NOTE:
This motor weighs approximately 70 lbs.
We recommend having a second person help with
the installation.
2c
Right
Sideplate
View accessories
available for your
trolling motor at
minnkotamotors.
com.
1b
Screw
Left Sideplate
2d
Left Sideplate
©2016 Johnson Outdoors Marine Electronics, Inc.
Screw