MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 14

INSTALLING THE RIPTIDE ULTERRA
10
o. If installing directly to the boat deck, install
the motor with the Long Bolts (Item #2), Clipped
Washer (Item #4), Flat Washer (Item #5) and
Nylock Nut (Item #6). Orientate the Clipped
Washers so that the flat side of the washer is
towards the Base Extrusion. The Bolt should pass
through the Clipped Washer, the Rubber Washer
and then through the Boat Deck. The Bolt should
be secured by first adding the Flat Washer (Item
#5) to the Bolt and securing with a Nylock Nut
(Item #6). Leave at least 1/4" space between the
Hex Head Bolt and Clipped Washer and the deck
of the boat. This will leave enough space to slide
the Base Extrusion between the Clipped Washer
and Rubber Washer and into place.
NOTE: The Short Bolts are not used when
installing the Riptide Ulterra directly to the boat.
11
p. Slide the Base Extrusion into place under the
Bolts that were just installed.
q. If installing with a Quick Release Bracket,
the Base Extrusion should slide between the
Quick Release Bracket and the Clipped Washers.
Hold the Clipped Washers up on the Hex Head
Bolt, so the Clipped Washer will sit on top of the
Base Extrusion.
r. If installing directly to the boat deck, the
Base Extrusion should slide between the Clipped
Washer and the Rubber Washer. Hold the Clipped
Washers up on the Long Bolt, so the Clipped
Washer will sit on top of the Base Extrusion.
10 | minnkotamotors.com
10o
Long Bolts
Clipped
Washer
Rubber
Washer
Flat Washer
Nylock Nut
11q
Power Tilt
Quick Release Bracket
11r
Power Tilt
Rubber Washer
Boat Deck
Power
Tilt
Boat Deck
Clipped
Washer
Base Extrusion
Clipped
Washer
©2016 Johnson Outdoors Marine Electronics, Inc.
Base
Extrusion