MINN KOTA RIPTIDE ULTERRA Instructions D'installation page 16

INSTALLING THE RIPTIDE ULTERRA
13
v. At this point in the installation process the
Mount should be secured to the deck of the boat,
and the Motor can now be reassembled. The
Extension Damper can be slid back in place on
the Motor. This should be done so the shaft on
the Damper is pointing inboard. Reinstall the two
5/16" E-clips.
14
w. Replace the Right Sideplate.
x. Replace the Left Sideplate.
y. Replace the four sideplate Screws using a #2 or
#3 Phillips Screw Driver.
14x
Left Sideplate
Screw
12 | minnkotamotors.com
Screw
E-clips
14w
Screw
Extension Damper
Screw
Right Sideplate
©2016 Johnson Outdoors Marine Electronics, Inc.