Gaskets, Oil Seals, And O-Rings; Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha RS90K Manuel D'atelier

IMPORTANT INFORMATION

GASKETS, OIL SEALS, AND O-RINGS

1. All gaskets, seals, and O-rings should be replaced when an engine is
overhauled. All gasket surfaces, oil seal lips, and O-rings must be
cleaned.
2. Properly oil all mating parts and bearings during reassembly. Apply
grease to the oil seal lips.

LOCK WASHERS/PLATES AND COTTER PINS

All lock washers/plates 1 and cotter pins must be replaced if they are
removed. Lock tab(s) should be bent along the bolt or nut flat(s) after the
bolt or nut has been properly tightened.

BEARINGS AND OIL SEALS

Install the bearings 1 and oil seals 2 with their manufacturer's marks or
numbers facing outwards. (In other words, the stamped letters must be on
the side exposed to view.) When installing oil seals, apply a light coating
of lightweight lithium base grease to the seal lips. Oil the bearings liberally
when installing.
CAUTION:
Do not use compressed air to spin the bearings dry. This causes
damage to the surface of the bearings.

CIRCLIPS

All circlips should be inspected carefully before reassembly. Always
replace piston pin clips after one use. Replace misshapen circlips. When
installing a circlip 1, make sure that the sharp edged corner 2 is posi-
tioned opposite to the thrust 3 it receives. See the sectional view.
4 Shaft
®

LOCTITE

After installing fasteners that have LOCTITE
before using the machine. This will give the LOCTITE
erly.
1-3
GEN
INFO
®
applied, wait 24 hours
®
time to dry prop-