Battery Pack; Traveling Outside Of The U.s - Medela Pump In Style Advanced Mode D'emploi

2. assembly (cont.)
Note
• Remove the batteries if the Battery Pack
is not going to be used for an extended
period of time.
• If breastpump does not turn on, make
sure the batteries have been inserted
properly. If this does not solve the
problem refer to the troubleshooting
section of this instruction booklet or
contact Medela Customer Service at
1-800-435-8316.
• Each set of batteries will provide
approximately 2 hours of pumping time.
22
2.3 Power options (cont.)

2.3.2 Battery Pack

1
Use 8 AA rechargeable batteries
or alkaline batteries.
4
Replace battery cover.
2
Replace all batteries at the
same time.
Slide off both battery covers.
Four (4) batteries are placed on
each side of battery pack.
2.3.3 Traveling outside the u.S.
When traveling outside of the U.S., there are 2 power options:
or
Use the Battery Pack that was
included with your Pump In Style ®
Advanced breastpump.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
3
Place the NEGATIVE (-) end of the battery
against the front of the spring by pushing the
battery in and down in one motion until the
battery snaps into place.
The POSITIVE (+) end of the battery should be
near the positive sign on the battery pack.
Purchase the 9 volt Vehicle Lighter Adaptor
(sold separately). Locate a Medela Retailer
at: http://medela.findlocation.com or visit our
online store at www.shopmedela.com.
23