Medela Pump In Style Advanced Mode D'emploi page 10

Masquer les pouces Voir aussi pour Pump In Style Advanced:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. assembly (cont.)
Warning
• Use only the power adaptor supplied with
the Pump In Style Advanced.
• Always inspect the 9 volt power adaptor
and Battery Pack cords prior to use for
damaged, kinked, twisted, frayed or
exposed wires. If damaged, immediately
discontinue use and call Medela
Customer Service at 1-800-435-8316.
Note
• See Section 2.3.2 Battery Pack
Assembly for instructions on the use of
the Battery Pack.
• See Section 2.3.3 Traveling Outside
the U.S. for information on using your
device internationally.
18
2.1 assembly of pump kit
(cont.)
7
Insert hard yellow adapter ends
of tubing into hole on the back
of breashield connectors.
10
Plug the metal fitting on end of
9 volt power adaptor or Battery
Pack cord into the power jack on
front of breastpump faceplate.
8
Double pumping: Insert
free ends of tubing onto both
ports on front of breastpump
faceplate.
11
Plug 9 volt power adaptor into
a standard electrical outlet.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
9
Single pumping: Insert free end
of tubing onto one port on front
of breastpump faceplace. Place
port cap over the unused port.
19

Publicité

Table des Matières
loading

Table des Matières