Assembly; Assembly Of Pump Kit - Medela Pump In Style Advanced Mode D'emploi

Masquer les pouces Voir aussi pour Pump In Style Advanced:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. assembly

Parts you will need for this step:
• Breastshield
• Breastshield
connector
• White membrane
• Yellow valve
• Breastmilk bottles
• Tubing
and lids
• Battery pack
or
• 9 volt power
adaptor
• Breastpump
or
• Metro motor
Note
• Inspect valves for cracks or chips and
inspect membranes for holes, tears or
warping. If you notice any damage to
these parts, replace them immediately.
16

2.1 assembly of pump kit

1
Wash hands before touching
breastpump, kit and breasts
and avoid touching the inside of
containers or lids.
4
Snap membranes onto valves
until membranes lie completely
flat on valve.
2
Place your breastpump on a
clean and dry surface. Ensure
that the surface is solid and
secure so your breastpump will
not tip over or fall.
5
Push assembled yellow valves and
white membranes onto bottom of
breastshield connectors.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
3
Securely attach breastshield to
breastshield connector.
6
Continued
next page.
Screw bottles onto breastshield
connectors.
17

Publicité

Table des Matières
loading

Table des Matières