If condensation appears in tubing:
To eliminate condensation after you have completed pump-
ing, continue running the pump with the tubing(s) attached
for another 1-2 minutes or until dry, while you attend to
storing your pumped breastmilk .
If milk appears in tubing:
1 . Turn off the pump and unplug from power source .
2 . Remove and disassemble the tubing, protective
membrane and membrane cap . Wash in soapy water
then rinse in cold clear water .
3 . Shake water droplets out and hang to air-dry . For
faster drying, attach tubings to pump and run pump
1-2 minutes or until dry, or pour a small amount of
isopropyl alcohol through the tubings to dry .
4 . Make sure that valve membranes are undamaged and
clean . Replace if necessary .
5 . Use a damp cloth to wipe the pump and the
diaphragm . Do not immerse the pump in water .
6 . When components are completely dry, reassemble
breastpump and kit .
Important Battery Care
Charge Symphony
Pump may be used while charging . Optimal battery life is
achieved when:
•
Batteries are not fully drained on a regular basis
•
Pump is allowed to charge when not in use
If unable to charge regularly, charge for 12 hours every
2 months at minimum
Pumping time with a completely charged battery is approx-
imately 60 minutes .
4
pump batteries for 12 hours upon receipt.
®