Powering Your Breastpump; Battery Operation; Display; Power Operation - Medela Freestyle 27260 Mode D'emploi

Masquer les pouces Voir aussi pour Freestyle 27260:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Preparing for Pumping (cont.)

4.3 Powering your breastpump

INFO

4.3.1 Battery operation:

If possible, do not remove the battery from the motor unit. Removing the
battery requires a charging time of up to 24 hours.
l The breastpump can be used during charging.
l The battery is charging as soon as the breastpump is connected to a power
source (even if the breastpump is not in use).
NOTE
l Do not use force to push the battery into the battery compartment.
l Do not use Freestyle without battery – this can cause permanent damage to
your Freestyle motor.
INFO
l If the breastpump has been
running for 30 minutes without any
manipulations, the Freestyle will
automatically switch off.
WARNING

4.3.3 Power operation

Follow the exact order of the steps.
l Only use the AC/DC transformer
supplied with the Freestyle
breastpump.
l Make sure the voltage of the AC/DC
transformer is compatible with the
power source.
20
Summary of battery charge status.
AC/DC transformer
connected to socket
Battery charge status
Battery fully charged, approx.
3 hours' expression
20 min. expression time
remaining. Battery removed
fl ashing
from motor unit
Low battery, needs charging
fl ashing
Initial charge and charging
"bAtt"
after removing the battery
fl ashing
(up to 24 hours charging
time)
4.3.1 Battery operation
1
2
Open the battery
Insert the battery in the
compartment on the
direction shown by "This
back by pressing the yellow
side down" so that the gold
push button and sliding in
contacts on the battery
the direction of the arrow.
touch the gold contacts in
the device.
4.3.3 Power operation
1
2
Open the yellow fl ap and
Plug the AC/DC transformer
plug the AC/DC transformer
into the mains socket.
cord into the motor unit.
*Battery must be in
compartment.
Questions? www.medela.ca, info@medela.ca or 1-800-435-8316

4.3.2 Display

1
Before fi rst use, "bAtt"
appears in the display. Fully
charge the battery until
the battery indicator stops
fl ashing.
21

Publicité

Chapitres

Table des Matières
loading

Table des Matières