Charge Battery - Medela Invia Motion Mode D'emploi

Charge Battery

When the battery is fully charged, it should last approxi-
mately 10 hours. If the Invia Motion NPWT Pump is run-
ning continuously due to an air leakage, the battery may
need to be recharged earlier ( after approximately 4 hours ).
Battery Status Symbols
full half full fully discharged (empty)
If the battery becomes fully discharged (empty), please
follow the instructions below.
Open the Direct Current (DC) socket by pulling the small
protective cover open. Connect the small end of the
power supply into the Invia Motion NPWT Pump.
Plug the large end of the power supply into a wall outlet.
The moving bars on the battery display will indicate that
charging is occurring.
19
200_4169_ifu_invia_motion_patient_EN_ES_FR.indd 19 17/02/15 12:07