Opex Sure Sort Traduction Des Instructions Originales page 308

Jam message
Optical Over-height
Sensor Blocked
Rear Safety
Controller not Reset
Return Conveyor E-
Stop Pressed
Safety Controller
not Ready
Software Error or
Software Problems
Detected
Stacker Door is
Open
Stacker Rear Door is
Open
Stacker Section 100-
Side E-Stop Pressed
154
Description
The Optical Over-height sensor is located on the input
section of the machine, and detects whether a piece
going down the conveyor exceeds the maximum
height limit of the system. If the sensor is blocked
upon startup of the system, a jam will be triggered.
The system has a safety interlock that will not allow
the system to run if the reset button attached to the
rear stacker door of the system is not pressed. The
reset button must be pressed each time the door is
opened from a safe state. The reset button will not be
active until the door is closed.
Occurs if the Emergency Stop (E-Stop) switch on the
motorized return conveyor has been pressed.
The system has a safety interlock that will not allow
the system to run if the controller is not in a ready
state. All safety features, including emergency stops
and door interlocks, must be reset in order to run the
system.
Occurs when an unexpected situation arises in the
software.
The system has a safety interlock that will not allow
the system to run if either of the stacker doors of the
system are open. The door does not have to be
completely open in order for this stoppage to occur. If
the interlock is broken, even briefly, the system will
stop and require a reset once all interlocks have been
satisfied.
The system has a safety interlock that will not allow
the system to run if the stacker door at the rear end of
the system is open.
Occurs if one of the Emergency Stop (E-Stop)
switches on the 100 side of the machine have been
pressed.
Sure Sort™ Operator Manual
OPEX Corporation
Statistics