Opex Sure Sort Traduction Des Instructions Originales page 298

Reject message
Abandoned at End
of Job
ELC Requested
Reject
ELC Timeout
ELC Insufficient
Return Data
Invalid Destination
Item Flushed
Failed to Unload at
Return Conveyor
Statistics
Description
The operator quit a job (left the Run screen by
pressing 'End Job') while the machine was in a
jammed state and there were undelivered pieces still
in the machine. When the system is restarted, the
undelivered items will be sent to the reject bin with this
reject reason as leaving the Run screen wipes the
destination locations from the associated pieces.
This is used for the piece database and between the
Host and ELC. In the piece database if you were to
look at the piece, the reject reason (if it originated at
the ELC) would be '24' in the Host reject column, then
whatever the ELC reject code was. The Host uses this
to increment its counts for ELC rejects (Host rejects
and ELC rejects are counted separately)
The Host did not receive destination data from the
ELC in the allotted time frame.
The ELC did not provide the Host expected data to
determine the destination for the inducted piece. This
should never occur.
This code will only be used for the Sure Sort XL
machine. The destination assigned to the piece is not
a valid location in the configured bin map.
This code will only be used for the Sure Sort XL
machine. If input conveyor restarts with pieces
beyond the tracking point, the items are flushed and
rejected.
This code will only be used for the Sure Sort XL
machine. The iBOT was unable to unload the piece
onto the return conveyor. The piece will then be sent
to the reject bin.
Sure Sort™ Operator Manual
OPEX Corporation
149